How To Install The Latest Version Of Nginx On Ubuntu 12.10

The packages that you will need to install are python-software-properties and software-properties-common (which is only necessary if you are running Ubuntu 12.10).

To install the first package dependency, python-software-properties, you will need to run the following command:

sudo apt-get install python-software-properties

If you are on Ubuntu 12.10, you should run the following command to install software-properties-common, which is another package that is necessary (without it, the add-apt-repository command used in Step Two will not be found).

sudo apt-get install software-properties-common

To ensure that our web server software is secure to run on a VPS, we will be using the latest ‘stable’ release.

If you are developing a nginx module, or if you need to use the “bleeding edge” version, you can replace the ‘stable’ version with the ‘development’ version. However I would not recommend doing this on a VPS, as there may be bugs.

Now that we have the latest stable package installed, we can now add the repository to install the latest version of nginx:

sudo add-apt-repository ppa:nginx/stable

Note: If this command still does not work (normally on 12.10), run the following command:

sudo apt-get install software-properties-common

This will add the repository to Ubuntu and fetches the repository’s key. This is to verify that the packages have not been interfered with since they have been built.

After adding a new repository, you will need to update the list:

sudo apt-get update

To install nginx or update the version you already have installed, run the following command:

sudo apt-get install nginx

You can check to see that nginx is running by either going to your VPS’ IP address/domain, or typing in:

service nginx status

This will tell you whether nginx is currently running.

If nginx is not running correctly, and/or prints out an error e.g. nginx: [emerg] bind() to [::]:80 failed (98: Address already in use), you can run:

netstat -tulpn

This will list all processes listening on ports. You should see something like this:

The highlighted number, the PID, is the number that you will use to kill the process. In this case, you would need to run kill -9 734. However the general code to copy into your terminal would be:

kill -9 xxxx

The phrase, “xxxx”, is the PID of the process you want to kill. After killing the process, you can try restarting nginx again by running:

service nginx start

Alternatively, the issue may be caused by the configuration accepting connections from both ipv4 and ipv6. In order to resolve this, edit out “listen [::]:80” in your default config file (/etc/nginx/sites-available/default) and any other server block config files that are in use.

sudo nano /etc/nginx/sites-available/default

The lines should look like this:

server {
        listen 80;
        #listen [::]:80 default_server;

Note:

You can view more information about the PPA release from: https://launchpad.net/~nginx/+archive/stable